Radiant floors, baseboard loops, boiler-fed zones, and hydronic heating systems require every component to work together. Viking Plumbing & Sewer provides expert diagnostics, repairs, maintenance, and system optimization to keep your home comfortable and your heating system operating efficiently.
Hydronic heat moves hot water through a closed loop instead of blowing warm air — quiet, even, and efficient when it's set up and maintained correctly. When a zone runs cold, a pump squeals, or the boiler short-cycles, we track down the cause instead of guessing.
PEX tubing embedded in a slab or subfloor, fed by a boiler or water heater. We handle loop balancing, manifold repair, leak detection under finished floors, and mixing valve adjustments so every room heats evenly.
Cast-iron and fin-tube baseboard runs lose efficiency when air gets trapped or fins corrode. We bleed air, flush sediment, replace damaged sections, and correct pitch so water circulates the way it's supposed to.
A pump that hums but doesn't move water, or a zone valve stuck open or closed, is one of the most common reasons a hydronic system stops heating a room. We test, repair, and replace these components to get every zone firing on schedule.
A waterlogged expansion tank or the wrong system pressure causes banging pipes, relief-valve drips, and short-cycling. We recharge or replace tanks and reset pressure to spec.
When the boiler runs but the house stays cold, the problem is usually downstream — in the piping, controls, or aquastat, not the boiler itself. We trace the whole loop to find where heat is actually being lost.
Hydronic problems rarely fix themselves. The sooner a stuck zone valve or waterlogged tank gets addressed, the less strain on the rest of the system.
Call (425) 474-2544Hydronic issues are almost always a symptom of something upstream. We follow the loop until we find it — not just the room that's cold.
Leaks that go undetected don't stay small. What starts as a pinhole leak in a slab line or a slow drip behind a wall can quietly cause structural damage, mold growth, and inflated water bills for months before it becomes visible. The earlier a leak is found, the less damage — and cost — it leaves behind.
Water lines running beneath a concrete foundation can corrode or shift over time. A slab leak often shows up first as a warm spot on the floor or an unexplained rise in your water bill, long before any visible water appears.
Supply lines and drain pipes inside walls can leak slowly for a long time, especially around bathrooms and kitchens. Watch for peeling paint, soft drywall, or a musty smell in a specific area of the house.
A leak in the line running from the street to your home can show up as a soggy patch of lawn, unusually green grass in one area, or reduced water pressure throughout the house. These are often the hardest to spot without the right equipment.
Don't wait for it to become visible damage. Call now and we'll get a technician out to pinpoint the source with non-invasive detection equipment.
Call (425) 474-2544We locate the exact source of a leak before recommending any repair — so you're not paying to open up walls or floors that don't need it.
Our proven process ensures your hydronic heating system is diagnosed accurately, repaired correctly, and tested for reliable performance.
Tell us which rooms are cold, what noises you're hearing, and how the system has been behaving. We ask the right questions before we ever show up.
We check pressure, pump operation, zone valves, and flow at the manifold to isolate exactly where the loop is failing.
Before any work starts, you get a clear explanation of the cause and a written estimate — no surprises on the bill.
We fix the failed component, purge air, rebalance every zone, and confirm even heat before we leave.
From a single cold zone to a full system flush, Viking Plumbing & Sewer diagnoses hydronic heating problems correctly the first time.